Shanghai Daoqin Plastics Co., Ltd.

injection molding 厂 production or injection molding quality fault/failure 时, injection molding machine need 临时停 machine or long time machine. how to good machine as, not only to lower one-time molding quality and raw materials loss consumption amount, also effect/influence to screw and material use lifespan.

一．临时停 machine positive good in molding 完毕之 front or 临时停止之 front, will material type material 空射完, again add amount 清洗材 material will material 筒清洗 dry 净, add hot 开关, material electrical hot. material sheet/plate. if is short time machine, need material electrical hot, will add hot temperature degree reduce 100至150 degree.

二．关 electrical machine material use or product already production 完毕, must electrical machine. if injection molding machine has nozzle temperature degree adjustment use temperature degree adjustment device, will adjustment device 按钮旋转至0, make adjustment device 断开. this not only is is in lower injection molding as can in can can short time inner add hot add material 筒. is is anti already understanding resin in material inner, will add hot inner material 彻底清 remove （ for injection 几次）, again add amount 清洗材 material will material 筒清洗 dry 净, most rear will screw in most front 端位置. in 手动状态 lower, clamping （但不 need high pressure 锁模）, will injection base/seat, screw 退回停止位置. 关油泵马达, injection molding machine electrical 源