Shanghai Daoqin Plastics Co., Ltd.

        一, injection molding parts technology parameters

        (1) screw 直径: screw outer dimensions

        (2) screw has long degree: screw upper has long degree (MM)常以L table/sheet 示

        (3) screw long ratio L/D: screw has long degree and 直径之 ratio

        (4) screw pressure shrink ratio V2/V1: screw add material 段第一 螺槽容积V2 and amount most 未一螺槽容积V1之 ratio

        (5) injection molding 行程: screw most large 距离, screw rear most large 距离

        (6) injection 容积: screw 头部JIE面积 and most large injection 行程 乘积

        (7) injection amount: screw one-time injection PS most large weight (g)

        (8) injection pressure: injection 时头部预熔 material most large pressure MPa

        (9) injection speed degree: injection screw most large speed degree (mm/s)

        (10) injection time: injection molding 时, screw injection most short time

        (11) injection speed rate: mono time inner injection 理论容积; screw JIE面积×以 most high speed degree

        (12) screw speed: material material 塑化时, screw most low most high speed scope/range

        (13) can force: in mono time inner, can material material most large weight

        (14) screw 扭距: material material 塑化时, screw most large 扭矩(N/m)

        (15) 喷咀伸 long amount: 喷咀伸出 front sheet/plate, mold 安装平面 long degree

        二, clamping parts technology parameters  

        (1) clamping force: is 克服熔 material 胀模, make mold most large force

        (2) molding 面积: in mold cavity pressure lower, clamping force most large 投影面积

        (3) mold opening force: is product, make mold most large force amount

        (4) mold opening 行程: is product, make sheet/plate most large 距离

        (5) sheet/plate dimensions: front rear and sheet/plate mold 安装平 dimensions

        (6) modulus: injection molding machine upper can mold most large thick degree and most small thick degree

        (7) sheet/plate 开距: injection molding machine sheet/plate and sheet/plate most large and most small 距离

        (8) 拉杆间距: injection molding machine water direction and direction inner 侧 间距(mm)

        三, machine property can parameters

        (1) electrical machine most large 驱动功 rate: 驱动油泵 electrical machine rate (KW)

        (2) 油箱容 amount: liquid pressure system 油箱 额定容 amount

        (3) machine 体积: machine outer most large long × high × wide

        (4) weight: machine weight