Shanghai Daoqin Plastics Co., Ltd.

injection molding machine fault/failure how solution, injection molding machine 锁模出现 certain issues, how solution? 莱普乐 is provide solution injection molding machine issues 参考办 method.

       一, clamping machine 铰响声异常
异常 analysis: lubricated amount small or pressure large
处理办 method: 1, electrical lubricated add time 设置; add long lubricated time
          2, lubricated 油池油 amount is 否充足, separation device and lubricated tube/pipe is has 堵塞, lubricated tube/pipe has fracture; 清洗连接 lubricated ensure its 畅通
          3, 检查锁模油 pressure is ultra- 额定工 as pressure or is large; according to products low clamping force

       二, 开锁模爬行
异常 analysis: 1, sheet/plate and abrasion loss heavy 2, sheet/plate water degree and degree good 3, mold opening speed degree, pressure adjustment 不当
处理办 method: 1, 检查二 sheet/plate copper sleeve/set, and is abrasion loss; more abrasion loss parts and add strong/high lubricated 油  
          2, 检查二 sheet/plate and water degree and degree ①, use water 平仪调平 machine 身道轨②, adjustment sheet/plate slip make 拉杆伸直
          3, mold opening speed degree, pressure value ①, gas ②, adjustment speed degree and pressure value

       三, rear, other as as 时, 会自动 slow slow mold opening
异常 analysis: mold opening 阀泄漏
处理办 method: 启动油泵锁模终止, 按射台 or 射胶动 as, sheet/plate is rear 移; or more mold opening 阀

       四, 锁模动 as has mold opening as generate
异常 analysis: 1, 阀芯卡住 or 装错阀芯 
          2, electrical magnetic 阀线接错
处理办 method: 1, 检查开关模阀芯 is 否堵塞 or 装错; dry or heavy new 安装阀芯
          2, 检查线路; heavy new 接线

      五, 锁模不起 high pressure
异常 analysis: thick adjustment 不当
处理办 method:1, 检查模 thick adjustment is combined 适; 适当调松模 sheet/plate 间距

       六, 锁模不畅
异常 analysis: in has gas 进入
处理办 method: 听油路 has gas 声（震动噪音 generate ）; gas

      七, can 调模
异常 analysis: 1, 调模螺母 pressure cover/cap and 螺母间隙太 small
          2, 螺纹咬死
          3, sheet/plate slip 脚太紧
          4, 调模马达不工 as
          5, 接近开关, electrical appliances, device bad
          6, in or defect
处理办 method: 1, use 塞尺测 amount; adjustment pressure cover/cap and 螺母 间隙 
          2, 检查螺母 can 否转动; 修复螺纹, more 换螺母   
          3, slip is has 拉伤; 修复并 adjustment sheet/plate slip 脚
          4, 检查调模换 toward is 否卡死, is electrical; or 换阀
          5, 检查三 versus electrical pressure is versus, pressure; more parts  
          6, control and 各接点; heavy new 接线