Shanghai Daoqin Plastics Co., Ltd.

锁模 process generally separation is or 者说四段, large is fast ----- slow ----- high pressure; 
fast speed 锁模, according to mold structure,看 is sheet/plate, or has slip block, different mold setting fast speed 锁模时 pressure / speed degree /位置, in effect/influence efficiency lower, setting combined pressure / speed degree /位置. need attention/notes let mold also can is fast speed is 原则 
low pressure --- slow speed; this separation is most important & in 点动状态 lower, will pressure is 0, speed degree slow,位置置0,因 is machine 本身都 has 一 底 pressure, although pressure is 0, mold also is combined 起, in mold combined 起 之 rear,因 is is 0,起不 high pressure, this according to sheet/plate 显示 模 base/seat 位置, will low pressure 位置改 formed sheet/plate 显示 数 value; 
high pressure;  generally 讲, need according to product 投影面积 and material property can setting high pressure.设置适当 数 value rear, need again adjustment low pressure 保护,按 upper 一步, heavy new more positive low pressure 锁模 位置.以但 ensure has 效.
2
一, in ensure clamping speed degree front lower, low pressure clamping pressure setting can can low, need can can 靠抵消 clamping abrasion scratch retardant force （模 sheet/plate and large 柱子之 abrasion scratch retardant force, 动定模接触 rear 导柱导 sleeve/set abrasion scratch retardant force, 斜导柱 slip block abrasion scratch retardant force, also has sheet/plate and 支撑部 parts abrasion scratch retardant force and other and other ）即 can.
二, need 设置充 separation low pressure 保护行程（应 large product dimensions, has machine 械手时应 large machine 械手 夹 tool dimensions ）, large low pressure 保护行程会 effect/influence low pressure pressure low pressure time 准确设置, therefore need combined combined 适.
三, need low pressure 保护开始结束实际 time rear low pressure time formed large 于实际 time （余 amount 1秒 below/following, ensure in has material and 时停止 clamping as 信号输出）, low pressure principle is in low pressure time inner, electrical method to high pressure 信号, electrical 脑则判定 mold cavity inner has material, electrical 脑原则 upper 应停止 clamping 信号输出, meanwhile 报警并输出 mold opening 信号.
四, lower clamping force rear ratio/proportion clamping high pressure pressure, clamping force different machine system pressure is 一样, use mechanism can through high pressure pressure 准确预设 clamping force.
五, high pressure 行程位置先 setting large, 此时依 experience decrease small high pressure 行程位置, to method high pressure or machine method 伸直时, again micro large high pressure 行程, make clamping force can can achieve.
if has slip block, 保护位置一定 need large slip block high degree, pressure amount small.
low pressure mold has 一 检验 standards, 放一 0.5-2mm thick sheet/plate, mold method combined 拢就证明你设置 formed 功!