Shanghai Daoqin Plastics Co., Ltd.

一, machine front fine injection molding machine electrical and control system, cooling system, its is positive 常, requirements add lubricated 油, 按（旋）钮 is 否处于 positive 确位置, requirements 启动, 进行试运转.

    二, positive will mold in injection molding machine upper.

    三, raw materials need drying 时, in inner 按规定进行烘 dry.

    四, Raw Materials color is combined product requirements.

    五, setting parameters, according to mold specific setting 开, clamping and ejection and other parameters, mold positive 常, 平稳, safety.

    六, setting material 筒各段 temperature degree, preheating machine 床.

    七, in material temperature, mold temperature degree to parameters （ requirements ）时, 进行排 material, 预注, 并观察 material 流, its light slip, color uniform.

    八, setting add material amount, injection speed degree, holding pressure 转换点 and other parameters, add material need true material inner is has and material, hard material, metal material material inner.

    九, as process in need attention/notes temperature degree, pressure 变化, 如发现异常情况, machine, electrical machine 修员进行修理, rear in use.

    十, in in has or product and parts has 差异时应 in production, and report 检验员 or belt/tape long.

    十一, injection molding 工应每隔2 small 时收集 one-time parts, meanwhile as versus 应标记放置于同批 product 旁.

    十二, production in less scratch 拭, lubricated mold 两次, ensure mold inner outer dry 净, lubricated positive 常. as 业结束 rear 应清理 material material, as 业现场, requirements injection molding machine.

    十三, need 经常检查烘箱 temperature degree, high temperature material. in as process in need attention/notes safety, 不 随意 掉 safety plant/unit.

    十四, as 完毕应切断 electrical and machine 床开关, good machine maintenance and 卫生工 as.
 

injection molding 厂 safety made degree

safety production inner main/primary 包括思想, machine equipment, safety 设施, safety training, as is, use product use and 查伤亡事故处理 and other. methods factory 组织定期 safety 检查, grade tube/pipe 理人员 day 常巡回检查, 班组自我检查 and 交接检查.

一, safety production 检查

factory 建立定期 separation grade safety production made degree, degree one-time comprehensive safety production 检查.

二, day property production 检查

经常 property 检查包括 factory 组织, 部门经理组织 safety production 检查, safety and safety value day for 工 进行巡回安

full production and 班组进行班 front rear safety and other.

三, false day front rear safety production 检查

is for false day front rear 职工思想松懈而进行 safety production 检查.

四, 自检, and 交接检

1.自检: as front, rear for 自身处 ring and as need safety production 检查, 以便随时消 remove safety 隐患.

2.互检: between safety production 检查, can belt/tape versus 监督, 共同遵章守纪. 3.交接检: upper 道工序完毕, to lower

道工序 use or as front, 应由工 negative 责人组织工 long, safety 员, long and other has 关人员参 add, rear safety production 检查

and 验收, 确认无 safety 隐患, to combined requirements rear, can to lower 道工序 use or as.