Shanghai Daoqin Plastics Co., Ltd.

一. 本程序 separation is positive 常情况送检程序 and non positive 常情况送检程序二. production positive 常情况送检程序:1. positive 常情况 is production product dimensions combined standards dimensions requirements 2.早 upper machine formed rear, injection molding parts mold temperature degree to hot temperature degree.油 temperature positive 常,接一模 sample, cooling 5-10 separation left right, use plastics bag good,贴 good label, in label upper must production time, to 仪检室检验3. and other to upper 模检验出 以 rear,必 must again 接一模, cooling 5-10 separation 钟,装 good to 仪检室 again 检验,因 is rigid machine, injection molding parts stability,故 again 送一模检验4. and other 第二模检验出 以 rear, for 两次检验 report mono comparison,如两次检验出 data more large difference,说明该 product production positive 常(注: positive is 指检验出 data in quality scope/range inner).如两次 data 不一样, must 以第二模 data is standards,因 is in and other 第二模 product data rear, machine already production 3-4 small 时,说明 machine already stability lower, 当第二模 product 检验出 data in quality scope/range outer,说明 product production already positive 常应当进行 debugging,然 rear again 送检,送检情况应做 is positive 常 送检5.当第二模 product combined 格, product positive production. product positive 常时,每天需送样三次 to 仪检验室检验. time separation is upper:8点 in 午:13:30 separation lower 午:18点.如送检结果均 is positive 常, table/sheet product in positive production.如发现不 combined 格,则应知会 related debugging,此时送检情况做 is production positive 常情况送检6.每次换 electrical or 交接班 rear,都应接一模 sample 送仪检室检验三. production positive 常情况送检:1. production positive 常情况 is 指换模 and product combined quality requirements lower production 2.当换模 or product positive 常时,开 machine rear, and other mold temperature to process requirements.油 temperature. hot temperature degree stability lower rear,接一模, must cooling 5-10 separation 钟, packaging good rear,送 to 仪检验室检验3.当第一模检验出, product combined quality requirements, this must debugging process, and other 10-20 separation rear, again 接一模, cooling packaging rear to 仪检验室检验4. debugging product good rear, must again 送第二模,因第一模 production 时, machine 尚未完 full stability 5.当第二模检验完 formed rear, for 两次检验 report mono comparison,不 tube/pipe 两次检验出 data is same, must 以第二模 检验 report is 准,然 rear again 以第二次 data and rigid machine 时送检 product data comparison,看 debugging good product dimensions and rigid machine 送检验 product dimensions different in 哪里, again product standards dimensions and this 两次 差距 in 哪?也就 is and standards dimensions comparison,就 is in issues,看 product dimensions is large or small