Shanghai Daoqin Plastics Co., Ltd.

开锁模 is most easy generate 震动, 而震动 for machine lifespan and stability property has relatively large effect/influence, therefore in adjustment 开锁模时请 attention/notes below/following 事项: slow speed mold opening speed degree is mold speed degree, therefore speed degree in in speed below/following, generally using/adopting slow speed in pressure, is 锁模时模 sheet/plate has amount deformation generate clamping force, therefore pressure can large 一, generally in 50% left right, slow speed 位置视 machine type 而定, generally in mold to 一点点 位置时 is decrease/reduce mold opening time fast speed mold opening.

fast speed mold opening speed degree pressure can large 一 以 decrease/reduce mold opening time, fast speed mold opening and decrease speed mold opening 位置一定 need 适当拉开距离, is fast speed mold opening impact and property comparison large, must need 一段距离 消 remove property for mold opening 终止位置 effect/influence.

但 if 间隔距离太 large 就会延 long mold opening time, can will decrease speed mold opening speed degree pressure adjustment to very small, generally in 10—20 left right need can 够支持模 sheet/plate retardant force most small force can. in mold opening 终止 时候尽 amount need has impact elastic phenomenon. is elastic accelerated degree is non large, for machine abrasion loss is non large, and mold opening 终止位置无 method stability in relatively small scope/range inner.

fast speed speed degree can large decrease/reduce time, pressure need large, fast speed 锁模位置 need large product thick degree, in need to product thick degree is need is low pressure 锁模. low pressure speed degree generally control in 30%以 inner, pressure generally is 0, especially mold need control in mold elastic 簧/ slip block and other retardant force rear most small, to low pressure 保护 目.