Shanghai Daoqin Plastics Co., Ltd.

         precision mold in design 时考虑事项:

        1: for formed product and dimensions degree, resin flow direction, injection shot pressure 传达, by filling resin solid 情形. is mold design 者, need for product requirements 知悉, this is precision mold design 源头. therefore for product requirements need 如指掌.

        2: for formed product features, need for formed product features has very system table/sheet, main/primary is material 方面, formed product 形状, for lower mold design upper fine has based on.

        3: mold structure. structure and 普通塑模 structure solution/scheme is different. 普通 塑模 structure design solution/scheme can can has types is can 行, is 精模, has structure can can has effect/influence, therefore has precision mold structure solution/scheme can can requirements very 苛刻. main/primary is mold as for products effect/influence.

        4: mold rigid property and strong/high degree. 我 人 experience is mold rigid property very important, 我经常看 to mold and inner material use very mono thin, can 说也许他 mold can production, is has product upper issues is and mold strong/high degree has very 密切 关系, has very difficult 发现. if mold strong/high degree is mold fracture, is this is very combined 理 想 method, is mold design experience performance.

        5: 进胶口 and 横胶道 is control products important factors. for products methods has requirements, 胶点做靓点, for product has 想像不 to 效果.

        6: mold temperature 调回路, mold need control in temperature degree. 必需设置 resin flow direction need temperature degree 差, for/regarding thick 变化部需 has countermeasures. formed product 离模 瞬间, products mold surface temperature degree need 均一. this requirements mold cooling system need combined 理.

        7: 精模 精 degree requirements very high, processing mold processing methods very important. based on formed product separation products 部模穴, slow filament very commonly used. therefore design need need processing methods.

        8: in mold structure upper need combined 理, its it solution/scheme add. 如, 一 位置做 can can 会不理想, if mold trial rear 确实不理想, need rear solution/scheme.