Shanghai Daoqin Plastics Co., Ltd.

         as is injection molding factory most is main/primary production tool, it product 形状, specifications, dimensions, appearance light degree. mold material is 钢材, generally front 模/ rear formed.

         mold 保护

         due to mold tool has property precision property easy loss property and other features therefore mold safety 保护至关 important, 总体归 nano has below/following several 方面:

        1, anti 锈: anti injection molding machine mold has water / cold water /雨淋/手印 and other formed phenomenon.

        2, anti 撞: anti mold 因顶针 has fracture, 未回退 to 位而造 formed mold bad phenomenon.

        3, remove 刺: anti mold 因布抹/ material 冲/手抹/ water 口钳碰/刀碰而造 formed mold 毛刺.

        4, parts: anti mold less 拉杆/ gasket and other parts formed mold use process in loss bad.

        5, anti pressure: anti mold still has product 而锁模而造 formed mold pressure 伤.

        6, pressure: anti mold low pressure pressure large formed 伤害.

         its in 因顶针 has fracture, 顶针未回退 to 位, mold has product, less parts formed mold loss bad ratio/proportion relatively high, 且因发生 relatively is frequency 繁, therefore 85% above mold loss is therefore causes formed, mold repair use generally relatively high, therefore how 样避免此 type 情况 发生直接关系 to injection molding industry 利益.

         is anti mold loss bad formed production 延误, and high repair use, meanwhile is more good 节省人工资源, 安祺科技经 不断 research and 改进, using/adopting machine technology development 出 一款 product, is “ mold device ”.

         mold device, or mold device, also mold electronics 眼, can has 效保护价 value mold. injection molding machine mold system, in injection molding machine upper, can 直接检查 product is combined 格, and in clamping front has 无残留 material, anti mold loss. injection molding machine 运行时, cycle inner, mold can can is plastics or slip block 错位而 has loss bad 危险, 安祺以 anti this 情况发生, in 异常发生时自动 anti 止闭模并报警.

         if is has has mold 保护, formed mold loss bad, to lower 建议:

         mold repair precautions:

        1, mold 时, 避免碰伤 and water, need 平稳.

        2, anti agent, again a small amount of demolding agent.

        3, need for mold comprehensive and anti 锈处理: small dry type 腔, type 芯, ejection machine and and other water separation and material, 并喷洒 mold anti agent and coating 抹黄油.

         mold maintenance

         mold in 连续工 as process in, 因运动 process in easy formed parts abrasion loss, lubricant 变质, water, plastics material pressure and other issues, need mold maintenance.

         mold maintenance generally separation is day maintenance and lower maintenance

         mold day maintenance generally below/following 方面:

        1, remove 锈(appearance, PL面, mold cavity, type and other), 定期清理 separation type material;

        2, heavy new add lubricant (ejection machine 构, and other)

        3, more easy abrasion loss parts (拉杆, and other)

        4, other need attention/notes 方