EN
- Product Details
Basic Parameters
Arkema BESVO A MED
Arkema · PA11 · medical grade PA11
density (g/cm³)
1.04
MFR/关键参数
—
product features
medical grade ，FDA认证，标准 grade ， film grade ， type material grade
application areas
medical devices 、 food contact 制品、医疗管路
product introduction
Arkema (Arkema) is 全球领先 specialty 化学品企业，旗下Evatane EVA、Rilsan PA11 and Altuglas PMMA三大 Brand 覆盖从 elastomer 到 engineering plastics 完整产品 line ， widely used in 光伏、汽车、医疗 and 光学等领域。
⚙️ injection molding processing 参数参考
melt temperature 范围
160-210°C
mold temperature
20-40°C
drying conditions
60°C / 2h
injection pressure
50-80 MPa
molding shrinkage
—
processing 备注
增容 agent 常用
🧪 化学耐受 performance
优异 ✅稀酸/稀碱盐溶液醇类
good 好 ✔矿物油(短期)脂肪烃
受限 ⚠芳香烃halogen 代烃酮类
避免 ❌浓硫酸浓硝酸
🌟 material material 优势
EMA（乙烯-丙烯酸甲 ester copolymer ）具 has excellent extreme property and 相容 property ， is 高效 增容 agent and modifier 。EMA广泛 used for 多层共挤 film 粘合层、 engineering plastics toughened 、 hot melt adhesive 等领域。
📦 储存 and 处理建议
EMA pellets 储存条件同EVA。 processing 前60°C干燥2小时。避免高温 and 阳光直射。密封保存。
产地
法国/ China
material 筒 temperature
180-280°C
mold temperature
20-80°C
干燥要求
PA11需80°C预干燥
daoqinsh.com · Daoqin plastics · Arkema Arkema 专业供应商
📐 详细物 property 参数表
* 以上数据 is 典 type 参考值，具体以原厂TDS is 准
- If you have any questions about Arkema BESVO A MED PA11 medical grade, or would like to request Arkema BESVO A MED PA11 medical grade datasheet, MSDS, ROHS test report, SGS report, REACH certificate, FDA certificate, EU regulation certificate, UL certificate, or COC/COA report, please call our service hotline +86-192-7986-4570, or click Contact Us to leave us a message.
Product Features
- Arkema BESVO A MED PA11 medical grade Properties, Arkema BESVO A MED PA11 medical grade Product Parameters, Arkema BESVO A MED PA11 medical grade Performance Data, Arkema BESVO A MED PA11 medical grade Factory Report, MSDS, Material Safety Data Sheet, UL Yellow Card, SGS Report, RoHS, Food Grade Certification, NSF Drinking Water Standard, Product Information, Product Performance, Factory Report, Original Packaging, Authorized Distributor, Heat Deflection Temperature, Melt Index, Flow Coefficient, Impact Resistance, Impact Strength, Low Temperature Toughness, Low Temperature Impact Resistance, Melt Flow Rate, Processing Technology, Processing Parameters, Processing Temperature, EU RoHS, German FDA, US FDA, Japan FDA
